Where can I find the installation instructions for my ESS power case?

PN: PD10008, Rev: A01, Copyright Ferroamp Elektronik AB 2022. Document subject to change without prior notice. Verify that you have the latest version of this manual on our website. In this booklet you will find installation instructions for your ESS Power Case.

Does ESS require battery capacity?

• Battery capacity is no longer required by the Assistant. Instead, enable battery monitor and enter the capacity on the General tab in VEConfigure. ESS design and installation manual Page 24 Comparisons to Hub Assistents

How should the ESS power case be positioned?

Make sure that the ESS Power Case and the ESS Battery are positioned close enough for the premade battery cables to reach. Indoor environment protected from rain and direct sunlight. Ambient temperatures must not fall below 0 °C and not exceed 45 °C. The environment must be non-condensing, relative humidity below 95%.

How to connect ESS battery?

Make sure that all terminals are tightened to 2.5 Nm, use a torque wrench. Remove the cable grommet for the RJ45 cable, poke a hole, cut it open along one side and attach it around the communication cable. The ESS Battery is now connected!

How do I calibrate the ESS battery?

Turn on the EnergyHub. Close the breaker on the ESS Power Case. Close the breaker on the ESS Battery and press the start button for 5 seconds until it rings. When the system is on the battery will calibrate during the first 24 hours. During this time, you should set the charge reference to 1 kW in the system configuration ().

How do I install a victron energy ESS system?

Hub-2 \(v3\) Assistant - ESS Assistant 24 8.3. Hub-4 Assistant - ESS Assistant 24 9. ESS Quick Installation Guide 26 9.1. Step 1 - Understand how a Victron Energy ESS system works 26 9.2. Step 2 - Decide what type of ESS 26 9.3. Step 3 - Select the system hardware 27 9.4. Step 4 - Install all equipment